Port103Z STM32 development board

SKU : P103ZSTM32

Port103Z is a STM32 development board that features a STM32F103ZET6 device as the microcontroller, supports further expansion with various optional accessory boards for your specific application. It is ideal for starting application development with STM32F family.

Note: Optional accessory boards are NOT included in the price.

1.MCU: STM32F103ZET6 from STMicroelectronics, incorporates the high-performance ARM® Cortex™-M3 32-bit RISC core operating at a 72 MHz frequency in LQFP144 package. The STM32F103ZET6 offers high-speed embedded memories(512KB  FLASH, 64KB RAM), 12-bit ADC, 12-bit DAC, I2C, SPI, I2S, SDIO, USART, USB, and CAN.

2.Onboard 3.3V regulator, AMS1117-3.3

3. Power indicator

4. User LEDs: These LEDs are connected to the MCU pin via jumpers, used for indicating IO status or program running status while debugging

5.Reset button

6.User Buttons

7.Joystick, 5 directions

8.8M crystal, enables the MCU run at 72M frequency by frequency multiplication

9. 32.768K crystal, used for internal RTC, also supports clock calibration.

10.Programming interface (JTAG/SWD), onboard 20-pin JTAG/SWD header

11.USB connector, used for establishing USB communication between PC and the STM32 development board

12.USART1 pin header, supports ISP (In-System Programming) through USART1, as well as system signal output

13.IO expander, all the MCU pins are accessible on expansion connectors for further expansion

14.Power input/output header, 5V/3.3V, usually used for power output, or common ground with other user board

15.5V DC power jack

16.Boot modes configuration: jumpers for selecting STM32 boot space

17.Jumper for selecting power supply, powered from 5V DC jack or USB connection

18.USB enable jumper 

 - Short the jumper to enable the PC auto detection while USB connecting 

  - Open the jumper to disable

19.VBAT enable jumper, powered from battery is available via this jumper, an external battery is required

20.VREF jumper 

  - Short the jumper to connect VREF+/VREF- respectively to VCC/GND 

  - Open the jumper to connect VREF+/VREF- to other custom pins via jumper wires

21.User LEDs jumper 

 - Short the jumper to connect to I/Os that used in example code 

  - Open the jumper to connect to other custom pins via jumper wires

22.User Buttons jumper 

 - Short the jumper to connect to I/Os that used in example code 

  - Open the jumper to connect to other custom pins via jumper wires

23.Joystick jumper 

 - Short the jumper to connect to I/Os that used in example code 

  - Open the jumper to connect to other custom pins via jumper wires

Note:

 - Accessory board and programmer/debugger in the photos are NOT included in the price. 

 - Port103Z supports programming through USART port without programmer.

 - Port103Z provides JTAG/SWD debugging interface, yet does NOT integrate any debugging function, a debugger is required

Package Contains

 - Port103Z Development Board x 1

 - USB type A to Mini-B cable x 1

 - USB Power Cable x 1

 - 4-pin wire x 2

 - 2-pin wire x 2

 - User Guide CD x 1